Meru Networks 4339B Guide d'installation télécharger pdf (Page 41)

Installing the Access Points

Mounting Below a Suspended Ceiling

The optional suspended ceiling mounting kit allows the AP200 mounting bracket to

attach to suspended ceiling T-rails (see Figure 22).

Note:

To comply with NEC code, attach a grounding wire to any of the screws used

to attach the AP200 to the mounting bracket.

Figure 21: Mounting the AP200 to a Suspended Ceiling Rail

To mount an AP200 below a suspended ceiling:

1. Determine the location on the ceiling rail where the AP will be mounted and

remove the ceiling tiles.

2. Place each of the two caddy fasteners on the ceiling T-rail and twist to attach to

the rail.

3. Adjust the distance between the caddy fasteners by using the mounting bracket

holes as a guide.

4. Tighten the caddy fasteners in place using a standard screwdriver. Do not

overtighten.

5. Place each spacer on the caddy fastener stud. The spacer legs should contact the

ceiling

T-rail.

Caution!

Be sure to connect the Ethernet cable to the Ethernet port; the cable can

mistakenly be plugged into the Console port.

Suspended ceiling T-rail

Mounting bracke

Keps nuts with attached

locking washer

Caddy fastener(

Plastic spacer(s

)

00102

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 118 119

Pas de commentaire

Meru Networks 4339B Guide d'installation Page 41