Meru Networks 4339B Guide d'installation Page 105

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 119
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 104
USA
© 2009 Meru Networks, Inc.Regulatory Information 95
USA
Underwriters Laboratories
For the AP150 series, the AP300 series, AP200 series, and the OAP180, the following
statement and notices are applicable:
Use only with Listed I.T.E. equipment.
Notices
The unit is intended for installation in Environment A as defined in IEEE 802.3.af. All
interconnected equipment must be contained within the same building, including the
interconnected equipment's associated LAN connection.
Suitable for use in environmental air space in accordance with Section 300-22(c) of
the National Electrical Code, and Sections 2-128, 12-010(3) and 12-100 of the Cana-
dian Electrical Code, Part 1, C22.1.
FCC Radiation Exposure Statement
Radio Frequency Interference Requirements
The Interference Statement applies to the following APs:
z AP150
z OAP180
z AP201 Rev 2, AP208 Rev 2
FCC Part 15 Statement
This is to certify that the above models are shielded against the generation of
radio interference. Compliance is dependent upon the use of Cat 5e shielded
data cables or a Meru-supplied line filter. Contact Meru Support to obtain a line
filter, free of charge.
z AP300 series
Caution!
The radiated output power of the Meru Networks devices is well below the FCC
radio frequency exposure limits. However, the Access Point should be used in
such a manner that the potential for human contact during normal operation is
minimized. When installing and operating these devices, keep a minimum
distance of 20 cm (8 inches) between the antennas and any persons/users in the
vicinity.
Vue de la page 104
1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 118 119

Commentaires sur ces manuels

Pas de commentaire