Meru Networks 4339B Guide d'installation télécharger pdf (Page 56)

Installing the Access Points

Figure 28: AP150 Antenna Connection

3. Connect one end of the PoE 100BaseT Ethernet cable to the 100/1000 Ethernet

connector, shown in Figure 30.

Figure 29: AP150 Connector Panel

Vertical Mounting the AP150

To perform a simple wall mount using the keyholes on the back of the AP150:

1. Remove the attached mounting bracket from the back of the AP150.

2. Mark the location on the wall for two mounting screws. They are placed 4.3"

apart, center-to-center, or one above the other. If you are not using plastic wall

anchors, you must either center the mounting screws on a wall stud or use plastic

wall anchors.

3. Drill holes at the locations you marked:

— 3/16-inch holes if you are using plastic anchors

— 1/8-inch holes if you are using only the screws

4. If you are using plastic anchors, install them in the holes.

00172

ANT 2

RELOAD

RESET

Turn clockwise

to tighten

ntenna

ANT1 ANT2

LAN

DC 5V

CONSOLE

RESET RELOAD

00173

Power Ethernet

connection

Console

port

Reset

button

Reload

Antenna 1 Antenna 2

(reserved)

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 118 119

Pas de commentaire

Meru Networks 4339B Guide d'installation Page 56